Ready?

You have received your advanced connected vehicle devices from Force by Mojio.

Want to install them properly?
It’s easier than you might think.

STEP 1

Plug in and Drive

With the engine off, locate the onboard diagnostic (OBD-II) port.

This port is usually below the driver’s side dashboard, but it can be in several locations. See the image above for some likely locations. In some vehicle makes, the port is covered by a sliding panel.

Securely plug in the device. Make sure it plugs in all the way and is not loose, but be careful not to damage the pins.

The Force OBD plug-in device is designed to slide into the port snugly. If you are installing devices into multiple vehicles, we recommend you take a picture of each device label and note the vehicle in which it is installed.

After you plug in the device, take the vehicle for a quick drive to activate the device.

This shouldn’t take more than a few minutes. Make sure you drive in an area with good cellular coverage (i.e., not in an underground garage).

Step 1 plug in drive dashboard
Step 2 customize account

STEP 2

Customize your account

Sign in to the web app using the activation link sent to the account owner’s email. Don’t see that email? Check your spam folder. If you still don’t see it, click here.

Get the most from Force by inputting license plates and vehicle names, and adding drivers and geofences. There are many areas where you can set up and add info to get better insights.

Check out the guides here

STEP 3

See where your business is going

For full features, check out the Force web app on your computer at https://force-us.moj.io/.

On the go?

Get the mobile app

Step 3 see business

Ready to see what it can do for your business?

Questions? Call us at 806-855-8255 or email us at [email protected]